Licensed & Insured Plumbers in Toronto, Ontario

Our faucets can start dripping when internal components begin to wear out, like washers and valve seats, which is caused by turning faucets tighter and even mineral build-up in the water. As water pressures begin to exceed the PSI pressure reading set by your municipality’s utility supplier, water flow in your pipes can be affected, causing water to leak out your taps. If your faucet is leaking around the base, loose parts like adjusting rings and packing nuts could be to blame, and you may need to adjust or tighten them. Some homeowners attempt home plumbing installations, poorly install their faucets, and cause leaks, seeing the need for trained plumbers to repair them.

If you’re experiencing low water pressure, check your property’s two primary water shutoff valves since having either of these partially closed can result in water pressure changes. If you have temporarily low water pressure and spluttering, a pipe obstruction or blockage could be to blame – call a trusted plumber to diagnose and repair the issue. Talk to your preferred plumbing service provider about replacing or repairing your water pressure regulator if you’ve noticed water pressure shifts with minimal transition time. In some cases, leaks can be to blame for changes in water pressure, so check your home and property for wet areas and contact a plumber.

Calling a reliable plumber is the best action to take when you notice a slow-draining sink because they can diagnose and repair the issue. Soap scum and grease can cause slow-draining sinks, so try household ingredients like vinegar and baking soda to remove clogs. Use an auger, also known as a plumbing snake, to remove clogs from your slow-draining sink by inserting it into your drain, twisting it, and pulling out clogs. Debris can collect in the P-shaped pipe under your sink, known as the P-trap, which you need to clean out when it causes slow drainage.

You may be able to avoid leaks by booking plumbing maintenance with trusted plumbers who can identify and take care of potential problems before they arise. If you’re mindful of what you wash down your drain and avoid problematic materials like eggshells, paper products, grease, and similar, you may prevent damaged and leaky pipes. If you are mindful of what you wash down your drain and avoid problematic materials like eggshells, paper products, grease, and similar, you may prevent damaged and leaky pipes. Pipes exposed to low temperatures during a cold Canadian winter can be at risk of bursting or leaking – reduce the risk by insulating them or sheltering them from the elements.

Don’t be afraid to contact a trusted plumber when you have a foul odour in your drain, as they will know the most likely cause. Clogged drains can be a leading cause of bad smells in drains as they can harbour bacteria that thrive on blockages and produce terrible smells. If you don’t use a sink very much or have a clog, its P-trap can dry out, enabling sewer gas to enter your home and create pungent sulphur-like smells. Check your garburator if you smell an unpleasant odour in or around your sink because bacteria and rotting food on its blades may be responsible.

When your water heater tank is not large enough for the number of people in your household, it can result in there not being enough hot water for everyone! Your water heater’s thermostat may not be high enough, so check that it’s set to approximately 55°C, but never set it higher than 60°C, or it can put you at risk of burns. Heating elements, gas valves, and thermostats can all fail and stop your water heater from producing hot water, so contact your local plumber for help. If you have a pre-1997 water heater, discuss the prospect of a failed dip tube with your local plumber since a broken dip tube means water enters your pipes before it’s heated.

Leaks in pipes, faucets, and fixtures can often be to blame for high water bills, so discuss these possible problems with your local trusted plumber. Wasteful runoff and overconsumption of water from outdoor irrigation systems can be common causes of high water bills, so ensure yours is set up appropriately. Excess water use and high water bills can be associated with water-using appliances that haven’t been working at their best, such as dishwashers, water heaters, and even ice makers. Every day that you have a leaking toilet tank may mean you’re wasting hundreds of litres of water, causing a spike in your water bill.

• Turn off water and electricity: Burst pipes can be a health and safety hazard, so don’t hesitate to turn off the water and power supply to your home to keep everyone safe.
• Contact a plumber: Fixing a burst pipe requires the expertise of a trained professional, so contact a plumbing service provider as soon as possible.
• Clean up the water: Unless you suspect that your water contains sewage, start cleaning it up using towels, mops, and buckets.
• Document the damage: Burst pipes cause severe damage, so don’t underestimate the importance of documenting the damage by writing a list of losses and taking photos and videos for your insurance provider.

Inspect your toilet’s overflow tube when your toilet keeps running after you flush since the flush valve can require replacement. If your toilet has a faulty float, it may not be communicating to your fill valve that your tank is full, leading to it overfilling. Water level issues aren’t always to blame for running toilets, so check the rubber part in your toilet tank’s base, known as the flapper, which wears out and causes water to escape. Pay attention to whether the float arm in your toilet tank is bent or straight – you might solve your toilet water problem by straightening or replacing a bent float arm.

If your home has a water valve inside, turning off the water supply to your house is as straightforward as turning it clockwise — generally without tools. If your property has an underground water meter box, the water valve will be inside it – turn the water supply off with a pentagon socket wrench. Having a water meter key or pliers on hand is useful for accessing and turning off the water valve inside your outdoor water meter box. If you’re having trouble turning off the water supply to your house, reach out to a local plumber you trust.